Growing pot cover - 6mm hole

Each lid of the growing container is made of high quality plastic, which guarantees sufficient strength and elasticity of the lid. The design of the containers is black to reduce light transmission to the root system. Vessels are designed for INDOOR cultivation! Do not expose them to direct sunlight, due to possible overheating of the root system or twisting of containers due to high temperatures! The lid is enclosed by the edge that reinforces the lid. For the same reason,
that is, to reinforce the overall stiffness of the lid over the full length of the ribbing.

The lids are in four versions according to the left and right orientation. According to the water inlet opening for the lid, for the inlet manifold hose, which is in the highest row and the lid for the drain pipe of the growing container. On this perpendicular side of the lid there are seven holes for the plants, into these holes are fitted a plastic foam wheel, which is cut into half and supports the flower in its growing stage and defines its position in the hole, or its tilt to the light. When planting smaller plants like basil, all seven holes can be used, but in planting larger plants, such as cherry tomatoes, I recommend that you use alternative holes – meaning four holes in one container but only three above or below, so that the plants are growing between each other.